Hi,

my RG-16 configured (function switch 4 button held down while reconnecting the power plug) with Cable part #AC-RRN-10 is working like this:
function switch 1 : channel 1
function switch 2 : -
function switch 3 : channel 3
function switch 4 : channel 2
function switch 5 : -
function switch 6 : solo
function switch 7 : -
function switch 8 : FX Loop

Is it ok ? I would expect f.switch 2 : channel 2 (instead of f.switch 4)

Regards,
Jérôme

That's definitely wrong... I'm thinking that your cable was wired incorrectly. You can send it back to us to get it fixed if you like...

Coming back to "no switches momentary or grouped default setting" (Hold Function Switch 1), I can't hear relay 2 switching when I play with function switch 2.
RG-16 is the cause !

Thanks for your quick reply.

Regards,
Jérôme

What are you using to power the RG-16? Powering it with 9VDC (instead of 9VAC or 12VDC) is the most common cause of relays not switching.

That's right, my power supply was a bit low... Strange that only one relay didn't switch.
Anyway, now everything is working fine.

Thanks again for your support.

Regards,
Jérôme